(732) 389-3535 ICERESIN@RANGERINK.COM

Materials:

  • ICE Resin®
  • ICE Resin® Studio Sheet
  • ICE Resin® Molding Putty
  • ICE Resin® Tints: Turquoise
  • ICE Resin® Brushes
  • ICE Resin® Leather Cord: 2.5mm Brown
  • ICE Resin® Endcaps: 6mm Antique Silver
  • ICE Resin® S-Hook & Jump rings: Antique Silver
  • Vintaj Patina: Victorian Gold
  • Driftwood

  •  Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 1: Using any type of found wood, cut down into small pieces. Select piece of choice to use for the pendant. Our piece is approximately 1” x 1.5”.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 2: Paint bottom edge of wood piece with Vintaj® Patina in Victorian Gold. Let dry.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 3: Choose another piece of wood that is similar in shape and size to your originally selected wooden piece. Mix ICE Resin® Molding Putty According to package directions and mold both pieces together.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 4: Once mold is set, remove only the second piece of wood from mold. Keep your painted, original wooden piece in mold.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 5: Mix ICE Resin® according to instructions. Colorize using 2-3 drops of ICE Resin® Tint in Turquoise.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 6: Gently fill bottom portion of mold with resin and let dry 8-10 hours. Remove piece from mold. Trim & sand edges as needed.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 7: Mix a small amount of ICE Resin® according to package directions and paint a thin layer over entire piece for a smooth, gloss finish.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 8: Cut desired length of 2.5mm ICE Resin® Leather Cord along with 2- 2” pieces of cord. Soak Leather Cord in water for 1-2 minutes to soften and pat dry with a paper towel.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 9: My selected piece of found wood already had a pre-drilled hole however you can easily drill a hole with a hand drill. Thread Leather Cord through hole and tie into a knot at the top of pendant. Fill 6mm ICE Resin® Endcap half way with ICE Resin® Leather Adhesive.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 10: Fold one of the 2” lengths of cord into a loop and place into end cap along with one end of necklace. Let dry and repeat on the other side.

     Beach Driftwood Pendant by Kelly Krownowski | www.iceresin.com

    Step 11: Finish the necklace by attached an ICE Resin® Jump Ring and S-Hook into the end caps to form closure.